Artistry in Titanium
Tom Anderson

The Original Ti Cigar Punch (top) and the new Ti Cigar Punch II (bottom) 

Ti Cigar Punch

$225.00 to $245.00
see below...

The new Ti Cigar Punch features a spring loaded ejector. The main body and cap are machined from solid ø5/8" 6AL4V titanium and the plunger is machined from solid ø1/4" 6AL4V titanium. A heavy-duty stainless steel split ring is included so you can keep it handy at all times.

Three AS568A-010 Neoprene® O-rings secure the cap to the body when not in use. Just give it a firm tug to access the special stainless steel cutter head. After the plug has been cut, simply push on the end of the plunger and the stainless steel Torx® head screw pushes the waste out of the cutter.

Bands of grooves have been machined into both the cap and the body for secure control. And, the cutter head can even be removed for re-sharpening if necessary. With the heavy duty stainless steel split ring, an overall length of only 2 5/8" (not counting the split ring), and weighing just 1.6 ounces, carrying it with you is convenient.

The new "Ti Cigar Punch II" follows the same basic configuration as the original Cigar Punch, but has a different pattern of grooves and dots on the O.D. 

Titanium Cigar Punch Specifications:

Body: Machined from solid ø.625" 6AL4V titanium bar stock.

Cap: 1.00" long, machined from a solid bar of ø.625” 6AL4V titanium

Plunger: Machined from solid ø1/4" 6AL4V titanium bar stock

Seals: Three AS568A-010 Neoprene® O-rings

Ejector screw: 18-8 Stainless Steel Torx® 

Music Wire Internal spring

Includes a heavy duty stainless steel split ring 

Overall length: 2.625" (not counting the split ring) 

Weight: 1.6 ounces


*Note: Since each of these is hand made, all dimensions shown are approximate.

The price of either the original Ti Cigar Punch is $225.00. The New Ti Cigar Punch II is $245.00. Both prices include shipping and insurance in the Continental US.

Please email me to place an order:

Titanium Cigar Punch with the cap in place

Titanium Cigar Punch with the cap off

A stainless steel split ring is attached to the end of the plunger

Close-up of the stainless steel cutter head and ejector screw
Website Builder