These new Ti-Humidifiers are a perfect compliment to the humidors of cigar aficionados. Each is made from 1/16” wall Grade 9 seamless titanium tubing with solid 6AL4V titanium end caps.
The ø3/4” Ti-Humidifier has a total of 144 holes through the tubing, is 6” in length, and weighs 2.8 ounces. This size is recommended for humidors that are 1 cubic foot or smaller.
The ø1” Ti-Humidifier has a total of 228 holes through the tubing, is 6 1/16” in length, and weighs 4.4 ounces. This size is recommended for humidors with a capacity of 2 cubic feet or smaller.
Both Ti-Humidifiers work on the same principal: The holes through the tubing wall allow controlled humidification provided by dehydration of the special silica beads inside. To recharge, simply submerge the humidifier in water for 3 to 5 hours, blot off the excess water, and place it in your humidor. Because they’re made from titanium, you won’t ever have to worry about rust, corrosion, mold, or mildew.
You can monitor the condition of the silica beads by holding the Ti-Humidifier vertically and looking into the holes. If the clear blue beads are below the halfway point, it’s time to soak the unit in water as noted above.
The recharging cycle can be repeated many times. If the silica beads ever need to be exchanged for new ones, simply pull the end cap off, install new hydrated beads, and replace the cap. Two Nitrile O-Rings on the cap provide a positive seal. Extra (uncharged) silica beads are provided with each Ti-Humidifier.
The ø3/4” Ti-Humidifier sells for $250.00, which includes postage to US destinations.
The ø1” Ti-Humidifier sells for $300.00, which also includes postage to US destinations.
Sorry, no foreign orders can be accepted.
Email me if you'd like to make a purchase. (Just click on the link below.)